The global site of the UK's leading magazine for automation, motion engineering and power transmission
23 September, 2020

Product and Supplier Search


Novel profile produces high-performance axes

18 September, 2008

Festo has launched a family of electromechanical axes based on a new profile said to provide unprecedented rigidity, and "exceptional" feed force, speed, acceleration and torque resistance. Festo predicts that the EGC axes – which include models with feed forces up to 3kN, speeds up to 5m/s, and stroke lengths up to 8.5 m – will open up new applications for high-performance single- and multi-axis motion control.

Festo EGC axes

The axes (above) are said to deliver a performance gain of 100–200% over Festo’s previous generation, but to cost 10% less. In many cases, it will be possible to use a smaller axis and motor than was needed before.

The low-mass axis bodies are made from extruded aluminium with a computer-optimised cross-section (below), said to provide unprecedented rigidity and load bearing. The stainless-steel guide rails are mounted externally, allowing the carriage to accept large cantilever and offset loads that apply high moments of torque. The family includes both toothed belt and ballscrew versions that can accommodate carriage twisting moments of up to 185 Nm.

Festo EGC profile

The toothed belt versions are available with profile widths from 50–185mm, and stroke lengths of up to 8.5m. They can generate feed forces up to 2.5kN and can handle speeds up to 5m/s and acceleration rates up to 50m/s2. The external guide arrangement allows small belt pulleys to be used, often avoiding the need for a gearbox. The belts can be replaced without dismantling the axis, and the motor can be mounted at either end and on either side of the axis, so users do not have to specify the motor position when ordering an axis.

The ballscrew versions are especially suitable for short cycle time applications needing high feed forces and accurate and repeatable positioning. They are available with 70–185mm wide profiles and stroke lengths up to 3m. They can generate feed forces up to 3kN, and can provide positioning accuracies of ±20 microns.

Festo has also launched a series of flush-fitting inductive position sensors for use with the EGC axes. Rather than looking "into" the actuator to detect embedded magnets, they sense the presence of a flag plate on the moving carriage. This makes them easy to install.

  • To view a digital copy of the latest issue of Drives & Controls, click here.

    To visit the digital library of past issues, click here

    To subscribe to the magazine, click here



Birmingham 2020The next Drives & Controls Exhibition and Conference will take place in Birmingham, UK, from 25-27 January, 2021. For more information on the event, visit the Show Web site


"Do you think that robots create or destroy jobs?"



Most Read Articles